T4-72-12 Series Industrial blower fan

T4-72-12 Series Industrial blower fan
  • T4-72-12 Series Industrial blower fan
  • T4-72-12 Series Industrial blower fan
  • T4-72-12 Series Industrial blower fan
  • T4-72-12 Series Industrial blower fan

T4-72-12 Series Industrial blower fan,industrial fan,centrifugal fan,exhaust fan,supply fan,belt driven fan,centrifugal fan,centrifugal blower fan,air blower fan


  • Brand: YAOSEN MARINE

Details

 The new centrifugal fan T4-72-12 is improved, designed and developed on the basis of the original T4-72-11 fan. The fan has the advantages of high efficiency, low noise and flat performance curve. Effective working range and wide efficient area.
 
The fan has 3 / 3. 5 / 4 /4 . 5 / 5 / 6 / 8 / 10 and so on. The installation size of the new series fan is changed except for the motor with Y series motor. The other mounting dimensions are the same as the original T 4-72-11 machine.
 
use
 
The T4-72-12 fan is still used for the same purpose as the original T4-72-11 machine, and can be used for general ventilation and ventilation, that is, for indoor ventilation in general factories and large buildings. It can also be used for smoke and dust removal and boiler blast. It can be used as both input gas and output gas. The type of conveying gas is air and other non-spontaneous combustion, which is harmless to human body. Gases that are not corrosive to steel plate materials. There shall be no viscous matter in the gas containing dust and rigid particles not greater than 150 mg / m3. It shall not exceed 80 ℃.
 
type
 
The fan can be made into two types: right rotation and left rotation. From the motor, the impeller rotates clockwise, which is called right rotating fan, expressed as "right". Rotating counterclockwise, it is called left rotating fan. As "left".
 
The outlet position of the fan is expressed by the air outlet angle of the housing. Model T4-72 fan 3-6 is made into one type in the factory. The unit of use shall be reinstalled to the required position according to requirements. When ordering, there is no need to indicate. 3-3.5 outlet position adjustment range 0-210 degrees, interval 30 degrees. The position of the outlet is adjusted from 0 to 225 degrees, with an interval of 22.5 degrees. The transmission mode of Li 3-6 is a type A. the position of the outlet is made into three fixed types of 90 degrees: 0 degree and 90 degrees. 180 degrees. Can not be adjusted, need to be specified when ordering. The transmission mode of 8-10 is C typeDrive.
 
structure
 
The fan is mainly composed of impeller, housing, inlet and other parts with direct motor. In addition to the above-mentioned parts, there are transmission parts.
 
1) according to the ISO international standard G6.3 balancing accuracy, the impeller has been calibrated by dynamic and static balance, with small vibration and smooth operation.
 
2) the 3-10 fan can not be disassembled, the impeller can be removed from both sides of the impeller, but the impeller can not be used.
 
3) the air inlet is made into a whole, which is arranged on the side of the fan, with a curve type parallel to the axial section, which can make the gas enter the impeller smoothly, and the loss is relatively small.

4) the transmission part consists of spindle, bearing box, rolling bearing and belt wheel.

Please contact us and get detailed Technical parameters and Drawings.
 
We could Design and Produce the Marine fan,Industrial Fan,and Other Ventilation Equipment according to your detailed requirement !

Inquiry

INQUIRY NOW
  •  
  • * (All * must be filled in)

Related Products